10 Watt Non-Inductive + Non-Magnetic
PathAudio Resistors - developed and designed for the best quality of Hi-End Audio reproduction. Their design ensures excellent transmission of the full audio bandwidth, without audible distortion, and with an extremely low noise floor. PathAudio Resistors have a wide frequency response with negligible low impedance phase shift, providing superior quality audio processing. They have 1% tolerance, a low temperature coefficient, high heat dissipation, and are fully resonant damped.
PathAudio Resistors employ thick film technology. The resistive layer is first applied to the ceramic molded body. Then it's dried at a high temperature and encapsulated with silicon cement. After applying a 0.8mm tinned copper wire, the resistor is almost ready to use...but for ultimate mechanical stability and to take advantage of it's shielding advantages, the resistors are encased in a copper tube and entombed with the best quality resin. The use of a copper tube case allows these parts to “drain" emi/rfi interferences. The third long lead out is used for this purpose. This lead is connected only to the outer copper case, and has no contact with the signal transmitted by the resistor. The third leadout should be joined to the ground or "-" speaker input.
PathAudio Resistors are perfect for loudspeaker cross-overs…allowing the sound to be smooth, clear, with superb dynamics.
•Tolerance +/- 1%
•10 Watt power rating
•Maximum voltage 1500 V
•Dimensions (length x diameter) 60 x 12 mm
•Wires: length 35 mm, diameter 0.8 mm
•Ground wire length 15-20 cm
•Value range from 0.5 Ohm to 100 Ohms (0R5 to 100R)
IMPORTANT NOTE: During pcX’s Monthly Sales, There is NO DOUBLE DISCOUNTING applied over and above any "special pricing” on any item, including items with quantity pricing.